User manual
3 Press the device rmly onto your skin to ensure proper skin contact.
The 'ready to ash' light on the back of the device lights up green to indicate
that you can proceed with the treatment.
4 Press the ash button to release a ash. You should feel a warm
sensation because of the ash.
Note: The light produced by the device is harmless to your eyes. It is
not necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
5 Place the device on the next area to be treated. After each ash, it takes
up to 3.5 seconds until the device is ready to ash again. You can release
a ash when the 'ready to ash' light lights up again.
6 To make sure that you have treated all areas, release the ashes close
to each other. However, make sure you ash the same area only once.
Flashing the same area twice doesn't improve the eectiveness of the
treatment, but increases the risk of skin reactions.
Two treatment modes: Stamp & Flash and Slide & Flash
Your Philips Lumea has two treatment modes for more convenient use on
dierent body areas:
- The Stamp & Flash mode is ideal to treat small or curvy areas like knees
and underarms. Simply press and release the ash button to release a
single ash.
- The Slide & Flash mode oers convenient use on larger areas like legs.
Keep the ash button pressed while you slide the device over your
skin to release several ashes in a row.
19
English