User manual

16
D Note:
Ifthelterwarningstillpersists,repeat
step 2.
3  Placeacontainerwithacapacityofatleast
10 litres under the pure water dispenser.
The pure water dispenser automatically
performs the PureFlush procedure, during
which10litresofwaterowoutofthe
appliance.
7.0.6 Replacing the UV lamp unit
B Warning:
AlwaysreplacetheUVlampunitwithanoriginal
PhilipsUVlamp(codeno.421530875020).
1  Switchoffthepurewaterdispenser.
2  RemovethecoveroftheUVchamber.
3  DisconnecttheUVlampwireconnectors.
4  UnscrewtheUVlampretainingcap.
•
7  Pushthelterholderbackintoplace(1)and
close the appliance door (2).
D Note:
Eachtimeyoureplacethelter,makesureyou
alsocleanthemacrolter(seesection‘Cleaning
themacrolter’above).


dispenser only operates normally again after you

7.0.5 Conrming lter replacement
1 Switch on the pure water dispenser.
Ifyoureplacedthelterduringthewarning
period(between2700and3000litres),
thelterindicator
cashes.Waituntilthe
dispense button dstartsashing(readyto
dispense - manual mode).
Ifyoureplacedthelterafterlterexpiry,
thelterindicatorlightsupcontinuously.
2  PressandholdtheLITRESbutton
and then press and hold the dispense
button.Keepbothbuttonspressed
simultaneouslyforatleast4seconds.
The pure water dispenser now
acknowledgesthenewlter.
Thelterindicator
c goes off.
•
•
•
•