User Manual

7
STUDIO WIZARD
REAR PANEL
12. AC Power Connector
This is a standard IEC power cable receptacle.
Plug the power cable in here and connect the
other end of the cable to an appropriate AC pow-
er supply.
13. “To Remote" Connector
This RJ-45 jack allows users to connect the main
unit of the Studio Wizard to the remote desk-top
controller.
14. Digital Inputs (S/PDIF and AES)
These RCA and XLR inputs accept signals in S/
PDIF (RCA) or AES/EBU (XLR) format. Trans-
fer rates are 24-bit, with sampling rates up to
192kHz (Mono).
15. Speaker Outputs
These three stereo 1/4" TRS outputs provide
balanced line-level signals for use with active
speakers/monitors or power ampliers driving
passive speakers. You can use the speaker trim
controls on the front panel to adjust the output
level.
16. Record Out 1 and 2
These stereo balanced 1/4" TRS and unbal-
anced RCA outputs provide line-level signals for
use with analog recording and dubbing equip-
ment.
17. Operating Level (Out) -10 dBV / +4 dBu
Use this switch to set the Record output 1 level
at -10 dBV, for use with semi-pro or consumer
level devices, or +4 dBu, for use with profession-
al audio gear. Record output 2 is permanently
set to -10 dBV.
18. Head Phone Outputs
These 1/4" TRS outputs provide balanced line-
level signals ideal for use with headphone distri-
bution ampliers.
19. Studio Outputs
These 1/4" TRS outputs provide balanced line-
level signals for up to two studio recording de-
vices.
20. Analog Inputs
These three sets of stereo 1/4" TRS inputs ac-
cept balanced line-level signals from up to three
devices.