FlexFlash Instruction Manual • Models SB – FLXFLSH400W, SB – FLXFLSH200W, SB – FLXFLSHE400W, SB – FLXFLSHE200W PROFESSIONAL PHOTOGEAR For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® Visit photoflexlightingschool.
Accessory release button Flash tube PROFESSIONAL PHOTOGEAR Slave sensor Modeling lamp Repositionable swivel handle FlexFlash Comes with: Protective Lamp Cover Seven Inch Reflector Power Cord For detailed specifications, product tutorial videos and more, please visit www.photoflex.com® 1 Sync Cable Spare Fuse stored inside Fuse Drawer Visit photoflexlightingschool.
Contents Safety Precautions ...............................................page Setting up the FlexFlash with Accessories ..........page FlexFlash Operation..............................................page Data Sheet ...........................................................page 2 2–3 4–6 7 The FlexFlash™ by Photoflex is a monobloc, self-contained flash unit. The power supply and flash head are in one unit, making it easier to use for location shooting than floor-generator powerpack type strobes.
locking mechanism, while rotating the connector counter-clockwise 1/16 turn. Carefully pull the FlexFlash away from the SoftBox assembly; avoiding contact with the flash tube or modeling lamp. Figure 4 Positioning the Light Height Adjustment – Use the LiteStand telescoping sections to get the desired height for the light. Figure 4 Using Umbrellas The Tilt Swivel Mount has a pass hole with an umbrella tightening PROFESSIONAL PHOTOGEAR screw for the umbrella shaft.
FlexFlash Operation The Rear Control Panel The rear control panel of the FlexFlash is where all adjustments are made for operating the features of the strobe unit. The Buttons will control navigation and selections shown on the LCD display. PROFESSIONAL PHOTOGEAR D E L G B H C M A A. Main power switch K J I F H. Modeling light power adjustment buttons B. Slave sensor/Pre-Flash control button I. Sync cord input C. Flash power adjustment buttons J. AC power cable input D.
The rear control panel of the FlexFlash allows all of the operating features of the flash to be controlled from this one area. Below is a more detailed description and instruction for use for each of these features. A. Main Power Switch - Make sure the switch is turned off (O) when plugging in the power cord and when removing or installing a flash tube or modeling light. B. [Photocell] Slave Sensor – There are three user selectable options for this feature: a. Slave sensor off.
G. Modeling Light Function Button This button will allow navigation through the modeling light options such as: Proportional Sets the modeling light output to match the intensity of the flash power setting. Free Allows independent adjustment of the modeling light to use the unit as a continuous light and not a strobe. J. AC Power Cord Input A power cord is supplied for each FlexFlash unit. Use only the cord supplied.
FlexFlash Strobe Datasheet Model 200 watt/second Model 400 watt/second Domestic Item Number SB – FLXFLSH200W SB – FLXFLSH400W Export Item Number SB – FLXFLSHE200W SB – FLXFLSHE400W Flash Power 200 w/sec 400 w/sec Flash Power Adjustments: Decimal Display Fractional display 1/10th step, 2.0 – 6.0 2/10 step, 1/64 – 1/1 1/10th step, 2.0 – 6.0 2/10 step, 1/64 – 1/1 Recycle time Domestic .5 – 2 seconds 1 – 2 seconds Recycle time Export .
