Operation Manual

REAR TYRE

Rear tyre Pirelli 150/70 14" GTS 24 M/C -

66S TUBELESS

03_07

Spark plug dismantlement (03_07)

Proceed as follows:

1. Remove the access cover over the spark plug on the left-hand side of the scooter

and reach into the spark plug with your hand.

2. Disconnect spark plug HV wire cap «A» ;

3. Unscrew the spark plug using the spark plug wrench supplied;

4. When refitting, place the spark plug into the hole at the required angle and tighten

by hand until it is finger tight;

5. Use the wrench only for final tightening of the spark plug;

6. Place hood "A" fully over the spark plug.

THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. THE

MEASURES ON THE SPARK PLUG ARE DESCRIBED IN THE TABLE OF SCHED-

ULED MAINTENANCE. THE USE OF ELECTRONIC CENTRAL UNITS AND OF

NON-COMPLIANT ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN

THOSE PRESCRIBED MAY SERIOUSLY DAMAGE THE ENGINE.

N.B.

THE USE OF SPARK PLUGS OTHER THAN THE INDICATED TYPE OR OF

SHIELDLESS SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAIL-

URES.

3 Maintenance