Operation Manual

- Remove the oil seal on the roller bearing side

using a screwdriver.

- Remove the roller bearing using the specific tool

Specific tooling

020376Y Adaptor handle

020456Y Ø 24 mm adaptor

020363Y 20 mm guide

- Heat the roller bearing seat with a heat gun

- Use the specific tool to introduce and push the

bearing until it stops, with the shielded side facing

out

- Refit the ball bearing locking seeger ring

Specific tooling

020151Y Air heater

020376Y Adaptor handle

020359Y 42x47-mm adaptor

020412Y 15 mm guide

- Use the specific tool to fit and push the roller cas-

ing until it stops

- Refit the oil seal on the roller bearing side

- Lubricate the area between the roller bearing and

the ball bearing

Specific tooling

020038Y Punch