Operation Manual

Soap-based lithium grease with NLGI 3; ISO-L-
XBCHA3, DIN K3K-20
Handlebar
Removal
•
Remove the two handlebar covers as
explained in the Bodywork Chapter.
•
Remove the handlebar wiring fixing
clips and disconnect the electric con-
nectors from the brake levers.
•
Unscrew the fittings, then remove the
front and rear brake pump piping.
•
Remove the flexible transmission of
the accelerator and remove the throt-
tle.
•
Loosen the clamp fixing the handlebar
to the steering tube and pulling up-
wards, remove the handlebar, then re-
move the lower plastic cover.
N.B.
IF THE HANDLEBAR IS BEING REMOVED TO
REMOVE THE STEERING, IT IS ONLY NECES-
SARY TO TILT THE HANDLEBAR FORWARD
ONTO THE FRONT PART OF THE VEHICLE
WITHOUT REMOVING THE PARTS FITTED SO
AS TO AVOID DAMAGING THE SHAFTS.
Refitting
Carry out the above operations by working in the reverse order from those of the removal.
Locking torques (N*m)
Handlebar fixing screw 50 ÷ 55
The tilt mechanism
Suspensions MP3 250 i.e.
SUSP - 4