Operation Manual

Refit the electric motor; check the position is cor-
rect by means of the reference indicated during
removal.
The motor should be so positioned that it does not
protrude from the reduction unit mould, see figure.
Tighten the screws to the prescribed torque.
Locking torques (N*m)
Electric motor coupling screws 11 ÷ 13
Place the moulded washer of the flexible trans-
mission control lever shaft and the tongue.
Refit the flexible transmission control lever as
shown in the figure.
Refit the potentiometer (not forcing in the D-type
connector ensures a sole position) with the con-
nector directed to the opposite side of the hydraulic
pump.
Refit the hydraulic pump on the geared motor body
and tighten the screws to the prescribed torque.
Fit but not tighten the pump stem coupling screw
and refit the plastic protection cap.
The synchronisation procedure should be com-
plete when the installation is finished.
Locking torques (N*m)
Geared motor hydraulic pump tightening
screws 11 ÷ 13
MP3 250 i.e. Suspensions
SUSP - 23