Operation Manual

- Remove the mud guard clamping screw
- Remove the two screws fixing the bracket to the
engine
- Undo the wheel axle bracket, using the heat gun if necessary.
Refitting the rear wheel
To fit, follow the removal steps but in the reverse
sequence, being careful to fit the spacers on the
wheel axle as shown in the photograph.
Locking torques (N*m)
Muffler arm clamping screws 27 ÷ 30 Rear
wheel axle nut 104 ÷ 126 Shock absorber-
crankcase attachment bracket 20 ÷ 25 Lower
shock absorber clamping screw 33 ÷ 41 Nm
Rear brake calliper fixing screws 25 ÷ 30 Nm
Swing-arm
Removal
- Place the scooter on its centre stand;
- Remove the swinging arm/engine fitting shown in
the photo
- Move the engine back
MP3 250 i.e. Suspensions
SUSP - 49