Operation Manual

Action
Coolant level - check
Brake fluid level - check
Engine oil - replacement
Hub oil - check
Brake pads - check condition and wear
Sliding block / variable speed rollers - change
Tyre pressure and wear - check
Vehicle and brake test - road test
Suspensions - check
Steering - Check
Tilt locking gripper control cable - adjustment
60,000 KM
205'
Action
Spark plug - replacement
Throttle lever - adjustment
Air filter - clean
Engine oil - change
Valve clearance - check
Electrical system and battery - check
Coolant level - check
Brake fluid level - check
Engine oil - replacement
Hub oil - change
Brake pads - check condition and wear
Sliding block / variable speed rollers - change
Tyre pressure and wear - check
Vehicle and brake test - road test
Suspensions - check
Steering - Check
Tilt locking gripper control cable - adjustment
Checking the spark advance
The ignition advance is determined electronically
on the basis of parameters known by the control
unit. For this reason it is not possible to declare the
reference values based on the engine rpm. The
ignition timing value is detectable any time using
the diagnostic tester. It is possible to check wheth-
er the ignition advance determined by the system
does in fact correspond with the value actually ac-
tivated on the engine, by means of the strobo-
scopic light.
Proceed as follows:
- Remove the spark plug.
Maintenance MP3 250 i.e.
MAIN - 4