Operation Manual

Make sure the pre-filter and discharge tap O-rings
are in good condition.
Lubricate them and refit the gauze filter and oil
drainage tap, screwing them up to the specified
torque.
Refit the new cartridge filter being careful to lubri-
cate the O-ring before fitting it.
Change the engine oil.
Since a certain quantity of oil still remains in the
circuit, oil must be filled from cap "A". Then start
up the scooter, leave it running for a few minutes
and switch it off: after five minutes check the level
and if necessary top up without exceeding the
MAX level. The cartridge filter must be replaced
every time the oil is changed. Use new oil of the
recommended type for topping up and changing
purposes.
N.B.
THE ENGINE MUST BE HOT WHEN THE OIL IS
CHANGED.
Recommended products
AGIP CITY HI TEC 4T Engine oil
SAE 5W-40 Synthetic oil that exceed the require-
ments of API SL, ACEA A3, JASO MA specifica-
tions
Check
This operation must be carried out with the engine
cold and following the procedure below:
1. Place the vehicle on its centre stand and on
flat ground.
2. Undo cap/dipstick "A", dry it off with a clean
cloth and replace it, screwing down com-
pletely.
3. Remove the cap/dipstick again and check
that the level is between the min and max.
marks; top up if necessary.
MP3 250 i.e. Maintenance
MAIN - 9