Operation Manual

This section describes the operations to be carried out on the engine and the tools to be used.
Automatic transmission
Transmission cover
- To remove the transmission cover it is necessary
to remove the plastic cover first, by inserting a
screwdriver in the slotted holes. Using the clutch
bell lock wrench shown in the figure, remove the
driven pulley shaft locking nut and washer.
Specific tooling
020423Y driven pulley lock wrench
- Remove the cap/dipstick from the engine oil filling
hole.
- Remove the ten screws.
- Remove the transmission cover.
N.B.
WHEN YOU ARE REMOVING THE TRANSMIS-
SION COVER YOU MUST BE CAREFUL NOT
TO DROP THE CLUTCH BELL.
Air duct
Versione 250
- Remove the five screws on two different levels
as well as the small casing.
Engine MP3 250 i.e.
ENG - 2