Instructions

14
king on or with the device must have read and understood these operating instructions.
The laser module operator must have access to the operating instructions at the place
of use at all times.
3. Installation
Our laser modules are delivered in ready-to-install state. For commissioning, the device
only needs to be connected to the electrical power supply and adjusted to match the
machine's cutting line.
Under normal circumstances, the laser is delivered pre-adjusted in the bracket.
3.1 Installing the 40x210 series:
If you do make any changes to the laser‘s position yourself, please follow these steps:
Mounting screws B1
Mounting screws B2
Locking for
rotation axis
Tensioning screw A1
Tensioning screw A2
Mounting screws A
22mm shaft
Mounting
screws B
40x210 Series laser modules Base plate
Tensioning screw A1
Safety label
Tensioning screw A1
Step 1:
Using clamp screw A1, open up the bra-
cket so that the laser slots into it easily.
Use a 2.5 mm Allen key. Make sure that
the labels are not damaged.
Step 2:
After slotting in the laser module, release
clamp screw A1. The two jaws should now
hold the laser loosely.