Operation Manual

84 Pinnacle Studio 9
and jog buttons. The layout of each preview area is
similar to that of the Player during normal editing.
Setting playback position: A scrubber control across
the bottom of the tool lets you set the playback position
anywhere within the clip. You can also set the playback
position using the counter and jog buttons located
between the two preview areas.
Using the counters: The positions reported by all three
counters are relative to the beginning of the clip, which
is position 0:00:00.0. As with the counter on the Player,
you can adjust the counters in the Clip properties tool
by clicking in one of the four fields (hours, minutes,
seconds, frames) to select it, then using the jog buttons.
When none of the fields is explicitly selected, the jog
buttons apply to the frames field.
Transport controls: While the Clip properties tool is
in use, the transport controls in the center area
substitute for those that normally appear on the Player.
These special transport controls include a Loop
play/Pause button that can be used to cycle
repeatedly through the trimmed portion of the clip
while the trim points are being adjusted.
Setting the trim points: The left bracket
button
beside the counter in the left preview area, and the right