Operation Manual

Appendix B: Tips and tricks 283
section. If you have followed the naming convention
suggested on page 28, Studio will proceed to the next
section of tape and repeat the process until all required
clips from that source tape have been recaptured. Not
following the naming convention results in changing
source tapes much more often.
When Studio recaptures your clips, it will capture about
a second of extra footage at the start and end of your
clip. Studio automatically trims each clip to match the
exact start and end points you chose for your movie,
but this extra captured footage allows you to adjust
start and end points of each clip if you happen to
change your mind after recapturing. You can do this
either on the Timeline or with the Clip properties tool.
Starting with continuous timecode
To avoid the multiple captures problem altogether, we
recommend striping your tapes with timecode before
you begin to shoot, if possible (see “Continuous
timecode” on page 28).