ENGLISH 16:9 Rear Seat Entertainment Display ESPAÑOL DEUTSCH NEDERLANDS This product conforms to new cord colors. Los colores de los cables de este producto se conforman con un nuevo código de colores. Dieses Produkt entspricht den neuen kabelfarben.
Contents Contents ...................................................... 1 To fit the display ................................................3 To remove the display ........................................4 Dimmer Setting [DIMMER] .......................... 14 Entering the Setup Function ............................ 15 Functions to be set............................................
IMPORTANT SAFEGUARDS ENGLISH Please Read All of These Instructions Regarding Your Display and Retain them for Future Reference 1. Read this manual fully and carefully before operating your display. 2. Keep this manual handy for future reference. ESPAÑOL 3. Pay close attention to all warnings in this manual and follow the instructions carefully. 4. Never allow others to use the system until they have read and understood the operating instructions. 5.
Fitting and Removing the Display Precaution: • To prevent failure, be sure to turn the ignition switch or system power OFF before fitting or removing the display. Also take care not to grip the screen or buttons too firmly or to drop the display. • Do not let any water get on the terminals on the display or on the cable and do not allow the terminals to be shorted by a metal object or the like. This can cause system breakdown. • Be careful not to touch terminals on the display or on the cable.
To remove the display ENGLISH • Pull the lock release lever 3 and hold in that position, then slide the display and detach it from its base. • To prevent theft of the display, remove the display when leaving the vehicle. Base ESPAÑOL Mounting arm (sold separately) DEUTSCH FRANÇAIS ITALIANO Press the lock release button while holding the display. Keep holding the button and unplug the connector.
IMPORTANT INFORMATION About This Product • This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). • Do not place the display in a position where it will impede the driver’s visibility or affect the operation of your vehicle’s airbags or headrests. Precaution • Always keep the volume low enough for outside sounds to be audible. • Protect the product from moisture.
Before Using This Product To Avoid Battery Exhaustion ENGLISH Always run the vehicle engine while using this unit. Using this unit without running the engine can result in battery drainage. To Protect the LCD Screen of the Display ESPAÑOL • Do not allow direct sunlight to fall on the Display when this unit is not being used. Extended exposure to direct sunlight can result in LCD screen malfunction due to the resulting high temperatures.
Before Using This Product To Ensure Safe Driving This unit senses whether the parking brake is on or off. When installed in the FRONT, it is arranged so that video cannot be viewed while the vehicle is moving. The various settings and adjustments are also not possible while driving. (The following message will be displayed on the screen while the vehicle is moving.) Stop the vehicle in a safe place, apply the parking brake and wait for the message to clear before starting operation.
ENGLISH Resetting the System Resetting the Microprocessor ESPAÑOL Pressing the RESET button lets you reset the microprocessor to its initial settings without changing the setup function settings. Reset the microprocessor in the following cases: When using this product for the first time after installation. When the product fails to operate properly. When strange (incorrect) messages appear on the display.
Key Finder Component Parts and Features 7 Display Unit 1 Signal receptor This receiver receives signals from a remote control. 2 POWER button Switches power ON/OFF. 3 DIMMER button Selects the brightness level. 4 WIDE/MENU button Changes the method of enlarging 4:3 video to 16:9 video. Pressing this button for 2 seconds, and displayed the setup function. Once the setup function is displayed, its function is switched each time the button is pressed.
Basic Operation ENGLISH WARNING If this product is installed in a place where it is visible to the vehicle’s driver, you MUST always set the [LOCATION] to the [FRONT] setting. Failure to do so could result in distracting images being potentially visible to the driver while the vehicle is in motion. ESPAÑOL If this product is installed in a place where it is not visible to the vehicle’s driver, then you may choose the [REAR] location setting.
Basic Operation Volume Adjustment Adjust the volume of audio output from the built-in speaker. • Raise or lower the speaker volume. VOL PAL 12 The volume of the built-in speaker can be adjusted in a range of 0 to 30. (The volume level will be displayed for about 4 seconds.) Selecting a Source • Select the desired source.
Changing the Wide Screen Mode ENGLISH You can change the way in which normal video (aspect ratio 4:3) enlarges to wide video (16:9). Select wide modes to suit the kind of video you are viewing. 1. Display a source to view. (Refer to the previous page.) 2. Select a wide mode. ESPAÑOL DEUTSCH Each press of the WIDE/MENU button selects the wide mode in the following order: [FULL] = [JUST] = [CINEMA] = [ZOOM] = [NORMAL] = Exit to [FULL] Note: • Settings are stored for each source (VIDEO1, VIDEO2).
Basic Operation Wide Modes Available FULL Video with an aspect ratio of 4:3 enlarges only horizontally. Enjoy viewing video widened without missing parts. JUST Video appears more extended horizontally as it gets closer to both edges of the screen. Because video appears in about the same size as regular video around the middle of the screen, enjoy viewing it without feeling out of place. CINEMA Video enlarges vertically with a aspect ratio falling between FULL and ZOOM.
Operating the Setup Function Dimmer Setting [DIMMER] ENGLISH Viewing can become difficult after extended video viewing if the screen is too bright at night or when ambient light darkens. You can select the brightness level from three settings; HIGH, MID and LOW viewing. 1. Display a source to view. (Refer to page 11.) 2. Select a brightness level.
Operating the Setup Function Entering the Setup Function This system offers a number of functionality setup and adjustment features to make it easier to use. Customize the settings to suit your taste and environment. 1. Display the setup function. Press and hold the WIDE/MENU button for 2 seconds. 2. Select a function.
Brightness [BRIGHTNESS] ENGLISH You can make black appear darker or lighter (–24 to +24). Contrast [CONTRAST] You can make narrow or widen the gap between black and white (darken) (–24 to +24). Color [COLOR] ESPAÑOL You can make colors appear lighter or darker (–24 to +24). Hue [HUE] You can adjust the red or green of the picture (–24 to +24). Note: • [HUE] cannot be adjusted for PAL video. DEUTSCH Location [LOCATION] When using the display for the first time, set its mounting location.
Using the Display Correctly CAUTION • If moisture or foreign matter should get inside the unit, turn OFF the power immediately and consult your dealer or the nearest authorized PIONEER service facility. Using the unit in this condition may result in a fire, electric shock or other failure. • If you notice smoke, a strange noise or smell, or any other abnormal signs from the display, turn OFF the power immediately and consult your dealer or the nearest authorized PIONEER service facility.
About the Liquid Crystal Display (LCD) Screen ENGLISH ESPAÑOL • If the display is near the vent of an air conditioner when it is deployed, make sure that air from the air conditioner is not blowing on it. Heat from the heater may break the LCD screen, and cool air from the cooler may cause moisture to form inside the display resulting in possible damage.
Connecting the System CAUTION • PIONEER does not recommend that you install or service your display yourself. Installing or servicing the product may expose you to risk of electric shock or other hazards. Refer all installation and servicing of your display to authorized Pioneer service personnel. • Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.
Note: OF OF No ACC position CAUTION • Cords for this product and those for other products may be different colors even if they have the same function. When connecting this product to another product, refer to the supplied Installation manuals of both products and connect cords that have the same function.
Connecting the System Names and Functions of Connection Terminals 7 Hide-away Unit 1 VIDEO1 RCA video input (yellow) Receives video, as from a VCR, DVD or other AV equipment. 2 VIDEO1 RCA audio input (white, red) Receives stereo audio, as from a VCR, DVD or other AV equipment. 3 VIDEO2 RCA video input (yellow) Receives video, as from a VCR, DVD or other AV equipment. 4 VIDEO2 RCA audio input (white, red) Receives stereo audio, as from a VCR, DVD or other AV equipment.
Connecting the Power Cable ENGLISH Hide-away Unit ESPAÑOL Power cable Fuse resistor Orange/white To lighting switch terminal. DEUTSCH Black (ground) To vehicle (metal) body. Fuse resistor Red To the electric terminal controlled by the ignition switch (12 V DC) ON/OFF. FRANÇAIS Do not connect this lead to power source terminals to which power is continuously supplied. If the lead is connected to such terminals, the battery may be drained.
Connecting the System Connection Diagram (VIDEO input) Display Unit White 3m VIDEO1 RCA audio input (white, red) VIDEO1 RCA video input (yellow) Hide-away Unit VIDEO2 INPUT VIDEO1 INPUT Commercial RCA cable (sold separately) To audio output Commercially available portable video component with RCA output To video output Note: • This system has display mounting location [LOCATION] settings [FRONT/REAR]. Be sure to complete these setting after the system has been installed. (Refer to page 16.
Connecting the RCA Audio and Video Output ENGLISH Hide-away Unit ESPAÑOL Power cable (Refer to page 22.) RCA video output (yellow) RCA audio output (white, red) Commercial RCA cable (sold separately) To audio input (R) To audio input (L) Second display, video deck, etc.
Installation CAUTION • For instructions on how to mount the display, consult your dealer. • Do not install the display where it may (i) obstruct the driver’s vision, (ii) impair the performance of any of the vehicle’s operating systems or safety features, including airbags, or (iii) impair the driver’s ability to safely operate the vehicle. • PIONEER does not recommend that you install or service your display yourself.
ENGLISH • If this product is installed in a place where it is visible to the vehicle’s driver, you MUST always set the [LOCATION] to the [FRONT] setting. Failure to do so could result in distracting images being potentially visible to the driver while the vehicle is in motion. If this product is installed in a place where it is not visible to the vehicle’s driver, then you may choose the [REAR] location setting. Use of this product is subject to any government laws regarding placement or use.
Installation a Installing the Hide-away Unit Installation Precautions • Never install in locations such as the following because of the danger of malfunction due to high temperatures or humidity: * Locations such as a dashboard or rear tray where there is exposure to direct sunlight. * Near heater outlets. * Near doors, etc., where there is danger of exposure to rain. • When installing under the front seat, make sure there is no hindrance to sliding of the seat.
Specifications General ENGLISH Power source ...................................................................... 14.4 V DC (10.8 — 15.1 V allowed) Grounding system ................................................................ Negative type Max. current consumption .................................................. 2.0 A Display Unit ESPAÑOL Screen size/Aspect ratio ...................................................... 6.5 inch wide/16:9 (effective display area: 143.75 × 76 mm) Pixels .............
PIONEER CORPORATION 4-1, MEGURO 1-CHOME, MEGURO-KU, TOKYO 153-8654, JAPAN PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-1111 PIONEER ELECTRONICS AUSTRALIA PTY. LTD.