GPS Receiver User Manual

ENGLISH ESPAÑOL DEUTSCH FRANÇAIS

ITALIANO NEDERLANDS

ENG/MASTER 96

Note:

Cords for this product and those for other

products may be different colors even if they

have the same function. When connecting this

product to another product, refer to the sup-

plied Installation manuals of both products

and connect cords that have the same func-

tion.

This product

Power cord

Black, Orange/white, Red, Yellow

☞

See Page 13.

Yellow/black

When combining this navigation unit with a Pioneer car stereo,

if the car stereo has yellow/black leads, connect them to those

leads. In this way, when the guidance audio is output and

when you operate the system by voice, the car stereo is

automatically muted to reduce the car stereo volume.

Connection method

Clamp the backup lamp

lead.

Clamp firmly with

needle-nosed pliers.

Backup lamp lead.

Fuse resistor

Check the position of your car’s backup

lamp (the one that lights up when the

shift lever is in reverse [R]) and find the

backup lamp lead in the trunk.

Purple/white (REVERSEGEAR SIGNAL INPUT)

This is connected so that the navigation system can

detect whether the car is moving forwards or back-

wards. Connect the purple/white lead to the lead

whose voltage changes when the shift lever is put

in reverse. Unless connected, the sensor may not

detect your car traveling forward/backward proper-

ly, and thus the position of your car detected by the

sensor may be misaligned from the actual position.

Note: When you use the ND-PG1 speed pulse gen-

erator (sold separately), please make sure to con-

nect it.

CRD3650A_inst_001_030_Eng 4/15/02 2:17 PM Page 13