Owner's Manual
Table Of Contents
- Quick Start Guide
- Operation Manual
- Reset
- Demo Mode (Menu Item)
- Table of Contents
- Parking Brake Interlock
- Using This Manual
- Parts & Controls
- Basic Operation
- Using the Navigation Menu Screens
- Displaying Rear View Camera Input
- Using the Map
- Customizing the Map Screen Settings
- Setting a Route to Your Destination
- Checking and Modifying the Current Route
- Advanced Operation
- Searching for and Selecting a Location
- Registering and Editing Locations
- Browsing Information on MSN Direct
- Registering and Connecting the Bluetooth Device
- Using Hands-Free Phoning
- Using the Radio
- HD Radio
- Playing Audio CDs
- Playing Music Files on ROM
- Playing a DVD-Video
- Playing a DVD-VR Disc
- Playing a DivX Video
- DVD-Video, DVD-VR, DivX Setup
- Playing Music Files (from USB or SD)
- Using an iPod
- Bluetooth Audio Player
- Using the XM Tuner
- Using the SIRIUS Tuner
- Using AV Input
- External Input
- Selecting the Video for Rear Display
- Picture Adjustments
- Customizing Preferences
- Navigation Settings Menu
- System Settings Menu
- Navigating the Menus
- Selecting the Language
- Setting the Time Difference
- Changing the Unit Between Kilometers and Miles
- Changing the Virtual Speed of the Vehicle
- Setting the Volume for Guidance and Phone
- Changing the Splash Screen
- Setting the Rear View Camera
- Touch Panel Calibration
- Illumination Color
- Checking the Version Information
- Replicating the Settings
- Turning Off the Screen
- AV Sound Settings Menu
- AV System Settings Menu
- Navigating the Menus
- Setting Video Input 1 (AV1)
- Setting Video Input 2 (AV2)
- Switching the Auto Antenna Setting
- Changing the Wide Screen Mode
- Setting the Rear Output
- Switching the Sound Muting / Attenuation
- Changing the Voice Output of the Navigation Guidance
- Acquiring / Cataloging iPod Music Information
- Displaying your DivX VOD Registration Code
- Operating the Navigation System by Voice
- Anti-Theft Function
- Additional Information
- Troubleshooting
- Error Messages
- Glossary
- Specs
- Installation Manual
- Table of Contents
- Note for Blue Wire
- Installation Hardware
- System Connections
- Power / Speaker Connections
- Speed Signal Connection
- Parking Brake Connection
- Reverse Gear Signal Connection
- Pre Amp Connection
- Rear View Camera Connection
- Connecting a Rear Display
- External Video Input Connections
- Mounting
- Installing the GPS Antenna
- Installing the Microphone
- Note on Voice Recognition Control
- Warranty
Before installing this product
! This product is for vehicles with a 12-volt
battery and negative grounding. Check the
battery voltage of your vehicle before instal-
lation.
! To avoid shorts in the electrical system, be
sure to disconnect the (–) battery cable be-
fore beginning installation.
To prevent damage
WARNING
! When replacing the fuse, be sure to only
use a fuse of the rating prescribed on this
product.
! When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
! This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
A
C
C
O
N
S
T
A
R
T
O
F
F
O
N
S
T
A
R
T
O
F
F
ACC position No ACC position
! To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
! Attach the connectors of the same color to
the corresponding colored port, i.e., blue
connector to the blue port, black to black,
etc.
! Refer to the owner’s manual for details on
connecting the power amp and other units,
then make connections accordingly.
! Since a unique BPTL circuit is employed,
do not directly ground the * side of the
speaker lead or connect the * sides of the
speaker leads together. Be sure to connect
the * side of the speaker lead to the *
side of the speaker lead on this navigation
system.
! If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
! Never connect speakers with an output rat-
ing of less than 50 W channel or impe-
dance outside of the 4 ohms to 8 ohms
specifications to your navigation system.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Notice for the blue lead
! A signal is output through the blue lead to
control the antenna of your vehicle. The
timing varies depending on the setting. (For
more detailed information on changing
[ANT CTRL] mode, refer to “Operation Man-
ual”.)
! When [ANT CTRL] mode is set to [Radio],
the vehicle’s antenna can be stowed or
turned off by following the instructions
below.
— Change the source from radio (AM or
FM) to another source.
— Turn the source off
— Turn off the ignition switch (ACC OFF)
! If [ANT CTRL] mode is set to [Power], the
vehicle’s antenna can be stowed or turned
off only when the ignition switch is turned
off (ACC OFF).
Connecting the System
En
6
Section
03