Operation Manual CD RDS RECEIVER DEH-6400BT English
Contents Thank you for purchasing this PIONEER product. To ensure proper use, please read through this manual before using this product. It is especially important that you read and observe WARNINGs and CAUTIONs in this manual. Please keep the manual in a safe and accessible place for future reference.
Section Before you start Private households in the member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal.
Section 01 Before you start Demo mode Important ! Failure to connect the red lead (ACC) of this unit to a terminal coupled with ignition switch on/off operations may lead to battery drain. ! Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. The demo starts automatically if you do not operate this unit within about 30 seconds since it was last operated or if the ignition switch is set to ACC or ON while it is turned off.
Section Operating this unit 02 Head unit 56 4 d c b a 9 The remote control CD-SR110 is sold separately. Remote controller buttons marked with the same numbers as on the unit operate in the same way as the corresponding unit button regardless of button name. f 87 i g h Operating this unit 1 2 3 Optional remote control j e 1 2 Part Part SRC/OFF AUX input jack (3.5 mm stereo jack) (list) 8 9 c 1 MULTI-CONTROL (M.C.
Section Operating this unit 02 1 After installation of this unit, turn the ignition switch to ON. SET UP appears. 2 Turn M.C. to switch to YES. # If you do not operate for 30 seconds, the set up menu will not be displayed. # If you prefer not to set up at this time, turn M.C. to switch to NO. If you select NO, you cannot set up in the set up menu. Demonstration (demo display setting) 1 Turn M.C. to set the demo display to off. 2 Press M.C. to confirm the selection. Quit appears.
Section Operating this unit 3 Always keep the detached front panel in a protection device such as a protection case. Re-attaching the front panel 1 Slide the front panel to the left. Make sure to insert the tabs on the left side of the head unit into the slots on the front panel. Notes ! When this unit’s blue/white lead is connected to the vehicle’s auto-antenna relay control terminal, the vehicle’s antenna extends when this unit’s source is turned on. To retract the antenna, turn the source off.
Section Operating this unit 02 Tuner Using PI Seek Basic operations If the tuner cannot find a suitable station, or the reception status deteriorates, the unit automatically searches for a different station with the same programming. During the search, PI seek is displayed and the sound is muted.
Section Operating this unit # PTY information and the frequency appear on the display for eight seconds. News&Inf News (News), Affairs (Current affairs), Info (Information), Sport (Sports), Weather (Weather), Finance (Finance) Popular Pop Mus (Popular music), Rock Mus (Rock music), Easy Mus (Easy listening), Oth Mus (Other music), Jazz (Jazz), Country (Country music), Nat Mus (National music), Oldies (Oldies music), Folk mus (Folk music) Classics L.
Section Operating this unit 02 ! The tuner automatically stores the three latest radio text broadcasts received, replacing the oldest text with the newest text. Function settings 1 Press M.C. to display the main menu. 2 Turn M.C. to change the menu option and press to select FUNCTION. 3 Turn M.C. to select the function. After selecting, perform the following procedures to set the function. ! If MW/LW band is selected, only BSM, Local and Tuning Mode are available.
Section Operating this unit CD/CD-R/CD-RW and external storage devices (USB, SD) 1 4 5 6 2 3 7 1 Bit rate/sampling frequency indicator Shows the bit rate or sampling frequency of the current track (file) when the compressed audio is playing. ! When playing back VBR (variable bit rate)-recorded AAC files, the average bit rate value is displayed. However, depending on the software used to decode AAC files, VBR may be displayed.
Section Operating this unit 02 Notes ! Depending on the version of iTunes used to write MP3 files to a disc or media file types, incompatible text stored within an audio file may be displayed incorrectly. ! Text information items that can be changed depend on the media. Selecting and playing files/ tracks from the name list 1 Press (list) to switch to the file/track name list mode. Play mode (repeat play) 1 Press M.C. to select a repeat play range.
Section Operating this unit Selecting a track (chapter) 1 Turn LEVER. Fast forwarding or reversing 1 Turn and hold down LEVER to the right or left. Selecting an album 1 Press or . Notes ! The iPod cannot be turned on or off when the control mode is set to AUDIO. ! Disconnect headphones from the iPod before connecting it to this unit. ! The iPod will turn off about two minutes after the ignition switch is set to OFF. Displaying text information Selecting the desired text information 1 Press /DISP.
Section Operating this unit 02 Operating this unit’s iPod function from your iPod You can listen to the sound from your iPod applications using your car’s speakers, when APP is selected. This function is not compatible with the following iPod models. — iPod with video — iPod nano 1st generation APP Mode is compatible with the following iPod models. ! iPod touch 4th generation (software version 4.1 or later) ! iPod touch 3rd generation (software version 3.
Section Operating this unit Audio adjustments 1 G.EQ (equalizer adjustment) You can adjust the currently selected equalizer curve setting as desired. Adjusted equalizer curve settings are stored in Custom1 or Custom2. ! A separate Custom1 curve can be created for each source. If you make adjustments when a curve other than Custom2 is selected, the equalizer curve settings will be stored in Custom1. ! A Custom2 curve that is common for all sources can be created.
Section 02 Operating this unit The cut-off frequency and output level can be adjusted when the subwoofer output is on. Only frequencies lower than those in the selected range are outputted from the subwoofer. 1 Press M.C. to display the setting mode. 2 Press M.C. to cycle between the cut-off frequency and the output level for the subwoofer. 3 Turn M.C. to select the cut-off frequency. 50Hz—63Hz—80Hz—100Hz—125Hz 4 Turn M.C. to adjust the output level for the subwoofer.
Section Operating this unit 02 Device list (connecting or disconnecting a device from the device list) Adjusting the other party’s listening volume 1 Turn LEVER while talking on the phone. ! When private mode is on, this function is not available. ! Turning private mode on or off 1 Press BAND/ while talking on the phone. Switching the information display 1 Press /DISP while talking on the phone. Notes ! If private mode is selected on the cellular phone, hands-free phoning may not be available.
Section 02 Operating this unit Special device (setting a special device) Device INFO (Bluetooth device address display) Bluetooth devices that are difficult to establish a connection with are called special devices. If your Bluetooth device is listed as a special device, select the appropriate one. 1 Press M.C. to display the setting mode. ! If three devices are already paired, Device Full is displayed and it is not possible to perform this operation. In this case, delete a paired device first.
Section Operating this unit Setting up for Bluetooth audio Basic operations 1 Pause (pause) 1 Press M.C. to turn pause on. Phone menu operation Important Be sure to park your vehicle in a safe place and apply the parking brake when performing this operation. 1 Press PHONE to display the phone menu. Operating this unit Before you can use the Bluetooth audio function you must set up the unit for use with your Bluetooth audio player.
Section 02 Operating this unit Phone Function (phone function) You can set Auto answer, Ring tone and PH.B. Name view from this menu. For details, refer to Function and operation on this page. Function and operation 1 Display Phone Function. Refer to Phone Function (phone function) on this page. 3 Turn M.C. to select the initial setting. After selecting, perform the following procedures to set the initial setting.
Section Operating this unit Warning tone (warning tone setting) If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone. 1 Press M.C. to turn the warning tone on or off. This unit’s rear output (rear speaker leads output and RCA rear output) can be used for full-range speaker (Rear SP :F.Range) or subwoofer (Rear SP :S/W) connection.
Section 02 Operating this unit Bluetooth device data can be deleted. To protect personal information, we recommend deleting this data before transferring the unit to other persons. The following settings will be deleted. ! phone book entries on the Bluetooth telephone ! preset numbers on the Bluetooth telephone ! registration assignment of the Bluetooth telephone ! call history of the Bluetooth telephone ! information of the connected Bluetooth telephone ! PIN code of the Bluetooth device 1 Press M.C.
Section Operating this unit 1 Press M.C. to display the main menu. 4 Press M.C. to select the desired setting. Clock display—elapsed time display—clock off 3 Turn M.C. to select the function. Selecting the illumination color 4 Press M.C. to display the MIXTRAX. This unit is equipped with multiple-color illumination. You can select desired colors for the keys and display of this unit. You also can customize the colors you want to use. 5 Turn M.C. to change the display.
Section Operating this unit 02 2 Turn M.C. to change the menu option and press to select ILLUMI. 3 Turn M.C. to display Key and press to select. 4 Turn M.C. to select the illumination color. You can select one option from the following list. ! ! ! ! 27 preset colors (WHITE to ROSE) SCAN (cycle through all colors) 3 sets of colors (WARM, AMBIENT, CALM) CUSTOM (customized illumination color) Notes ! When SCAN is selected, the system automatically cycles through the 27 preset colors.
Section Operating this unit 02 5 Press M.C. to select the primary color. R (red)—G (green)—B (blue) Operating this unit 6 Turn M.C. to adjust the brightness level. Adjustment range: 0 to 60 # You cannot select a level below 20 for all three of R (red), G (green), and B (blue) at the same time. # You can also perform the same operation on other colors. Notes ! You cannot create a custom illumination color when SCAN or a set of colors (WARM, AMBIENT, or CALM) is selected.
Appendix Additional information Troubleshooting Symptom Cause The display automatically returns to the ordinary display. You did not per- Perform operation form any opera- again. tion within about 30 seconds. Action Symptom Cause Action The sound from the Bluetooth audio source is not played back. There is a call in progress on a Bluetooth connected cellular phone. The sound will be played back when the call is terminated. Select the repeat The repeat play Depending on play range again.
Appendix Additional information CD player Message Cause Message Cause Action NO AUDIO There are no songs. Transfer the audio files to the USB storage device and connect. The connected USB storage device has security enabled. Follow the USB storage device instructions to disable the security. SKIPPED The connected USB storage device contains files embedded with Windows Mediaä DRM 9/ 10. Play an audio file not embedded with Windows Media DRM 9/10.
Appendix Additional information Message Cause Action Message Cause Action CHECK USB The USB connector or USB cable has shortcircuited. Check that the USB connector or USB cable is not caught in something or damaged. ERROR-23 USB storage device was not formatted with FAT12, FAT16 or FAT32. USB storage device should be formatted with FAT12, FAT16 or FAT32. The connected USB storage device consumes more than 500 mA (maximum allowable current). Disconnect the USB storage device and do not use it.
Appendix Additional information Handling guidelines Discs and player Do not attach commercially available labels or other materials to the discs. ! The discs may warp making the disc unplayable. ! The labels may come off during playback and prevent ejection of the discs, which may result in damage to the equipment. External storage device (USB, SD) Use 12-cm discs. Do not use 8-cm discs or an adapter for 8-cm discs. Use only conventional, fully circular discs. Do not use shaped discs.
Appendix Additional information Do not touch the connectors of the SD memory card directly with your fingers or with any metal device. Do not insert anything other than an SD memory card into the SD card slot. If a metal object (such as a coin) is inserted into the slot, the internal circuits may break and cause malfunctions. When inserting a miniSD or microSD, use an adapter. Do not use an adapter which has metal parts other than the connectors exposed. Do not insert a damaged SD memory card (e.g.
Appendix Additional information AAC Playable files: up to 15 000 Compatible format: AAC encoded by iTunes Playback of copyright-protected files: Not compatible File extension: .m4a Partitioned external storage device (USB, SD): Only the first playable partition can be played. Transmission rate: 16 kbps to 320 kbps, VBR Apple Lossless: Not compatible AAC file bought from the iTunes Store (.
Appendix Additional information iPod compatibility Example of a hierarchy 01 This unit supports only the following iPod models. Supported iPod software versions are shown below. Older versions may not be supported. Made for ! iPod touch 4th generation (software version 4.1) ! iPod touch 3rd generation (software version 3.1.1) ! iPod touch 2nd generation (software version 2.1.1) ! iPod touch 1st generation (software version 1.1) ! iPod classic 160GB (software version 2.0.
Appendix Additional information Copyright and trademark Bluetooth The Bluetoothâ word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by PIONEER CORPORATION is under license. Other trademarks and trade names are those of their respective owners. iTunes Apple and iTunes are trademarks of Apple Inc., registered in the U.S. and other countries.
Appendix Additional information Specifications General Power source ............................. 14.4 V DC (10.8 V to 15.1 V allowable) Grounding system ................... Negative type Maximum current consumption ..................................................... 10.0 A Dimensions (W × H × D): DIN Chassis ..................... 178 mm × 50 mm × 165 mm Nose ........................... 188 mm × 58 mm × 18 mm D Chassis ..................... 178 mm × 50 mm × 165 mm Nose ...........................
En 35
PIONEER CORPORATION 1-1, Shin-ogura, Saiwai-ku, Kawasaki-shi, Kanagawa 212-0031, JAPAN PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique TEL: (0) 3/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
