Stereo Equalizer Operation Manual DEQ-P8000

3 Touch or to select SUB WOOFER
(subwoofer).
Each time you touch
or selects the
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)PHASE (sub-
woofer setting)
4 Touch
to turn subwoofer output on.
# To turn subwoofer output off, touch .
5 Touch and then touch or to se-
lect the phase of subwoofer output.
Touch
to select normal phase and
NORMAL appears in the display. Touch
to
select reverse phase and REVERSE appears in
the display.
Note
When playing a 2-channel mono source with Pro
Logic B turned on, there may be occasions when
the following will occur:
! No audio is outputted if the center speaker
setting is SMALL or LARGE and no center
speaker is installed.
! Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL or LARGE.
Selecting a cross-over
frequency
If DVH-P7000, DVH-P5000MP or AVH-P6500DVD
is connected to this unit, operation is slightly
different.
You can select a frequency, under which
sounds are reproduced through the subwoo-
fer. If the installed speakers include one whose
size has been set to SMALL, you can select a
frequency, under which sounds are repro-
duced through a LARGE speaker or subwoo-
fer.
1 Touch A.MENU and DSP and then touch
NEXT.
2 Touch CROSS OVER.
3 Touch
or to select the speaker to
be adjusted.
Each time you touch
or selects the
speaker in the following order:
FRONT (front speakers)CENTER (center
speaker)REAR (rear speakers)
SUB WOOFER (subwoofer)
# If DVH-P7000, DVH-P5000MP or AVH-
P6500DVD is connected to this unit, you cannot
operate this procedure.
4 Touch or to select cut-off fre-
quency.
Each time you touch
or selects cut-off
frequencies in the following order:
6380100125160200 (Hz)
Note
Selecting a cut-off frequency is to set a cut-off fre-
quency of the subwoofers L.P.F. (low-pass filter)
and that of the SMALL speaker H.P.F. (high-pass
filter). The cut-off frequency setting has no effect
if the subwoofer is set to OFF and other speakers
are set to LARGE or OFF.
Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and DSP and then touch
NEXT.
Digital Signal Processor
En
13
English
Section
03