User Manual

PNI Sensor Corporation Doc #1017545 r03
SpacePoint Scout User Manual – January 2013 Page 16 of 19
6.3 Launching the Test Program
Launch the program by double-clicking on “SpacePointTestProgram.exe”. The program
Configuration window will appear, as shown below. The default settings normally work
well, but you can change them if you prefer. Note that if “Windowed” is unchecked the
program will launch in full screen mode. Click <Play!> to proceed.
Now the port configuration screen will appear, as shown below. Set the COM Port to the
appropriate port. If you are uncertain which port this is, in Windows go to the Device
Manager and click on Ports to see which Port shows a USB Serial Port. Set the baud rate to
115200. Click <Resume>.