User Manual

ManualsBrandsPoint Six ManualsElectronicsTemperature Sensor

Table Of Contents

Point Six, Inc. – 391 Codell Drive - Lexington, KY – 40509 - http://www.pointsix.com - 859-266-3606 – Fax: 859-266-0702

FCC ID: M5ZP6HWSO

Installation and Operation Instructions for the Setpoint Override Temperature transmitter HWSO .

Point Six Wireless

Wireless Setpoint Override Temperature Model HWSO

Installation and Operation Instructions

Description

The HWSO wireless module has a battery life of >8years. The pushbutton on the sensor has the following function:

Set/reset Override: Briefly press and hold until LED starts to flash or stops flashing.

This model may be configured as a, temperature sensor with or without override and setpoint.

The specific function is determined at the time of manufacture and is not alterable by the user

To start operation inset two 3.6 Volt Lithium AA cell. The LED will flash when override is activated.

Summary of content (5 pages)

PAGE 1
FCC ID: M5ZP6HWSO Installation and Operation Instructions for the Setpoint Override Temperature transmitter HWSO . Point Six Wireless Wireless Setpoint Override Temperature Model HWSO Installation and Operation Instructions Description The HWSO wireless module has a battery life of >8years. The pushbutton on the sensor has the following function: Set/reset Override: Briefly press and hold until LED starts to flash or stops flashing.
PAGE 2
Packet Description “MultiAnalog” (75/76) IDSSSSSSSSnnrraaaaAAAACCCCKK Note: All fields are in ASCII Hex “ID” The device type field: MultiAnalog has device type 76 hex. A 75 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the MultiAnalog device. The LS-2 bits are set to zero. “nn” The number of I/O points (1 byte field: 1 or 2). “rr” This 1 byte field is not used and contains generic 00 data.
PAGE 3
Packet Description “CountAnalog” (74/73) IDSSSSSSSSoooooottttLLCCCCKK Note: All fields are in ASCII Hex “ID” The device type field: Counter-Analog-Status has device type 73 hex. A 74 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the Counter-Analog transmitter. The LS-2 bits are the status flags for the switch input status. The LS bit (bit-0) is the Open status flag and the next most significant bit (bit-1) is the Closed status flag.
PAGE 4
Packet Description “Humidity2” (51/52) IDSSSSSSSSnnrrhhhhttttCCCCKK Note: All fields are in ASCII Hex “ID” The device type field: Humidity2 has device type 52 hex. A 51 hex when in service mode. “SSSSSSSS” The MS-30 bits of these 4-bytes are the serial number of the Humidity2 device. The LS-2 bits are set to zero. “nn” Always “00”. “rr” This 1 byte field is not used and contains generic 00 data. “hhhh” This is the humidity data field.
PAGE 5
FCC ID: M5ZP6HWSO MADE IN USA NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.