User manual

Product overview Operation
Do not set up or operate the product under water.
Make sure that the cables hang loosely and are not
stretched too tightly. Failure to heed this warning may
cause the cables to tear.
Do not fasten the product directly to the installation
surface, do not use, for example, any pushpins. First
install suitable holders and then lay the product on the
holders.
Do not connect the product to the power supply while
it is still in the packaging. Lay the product out entirely
before connecting it to the power supply.
Do not hang any objects from the product and do not
cover the product.
The LEDs are neither dimmable nor replaceable.
1. Lay the product out entirely and arrange the cables so that
they lie freely and are not tangled.
2. Select a suitable location for installation (e.g. window,
balcony, eaves). Use plastic cable ties to fasten the product if
necessary.
3. Insert the connector on the power cable into the
corresponding connection on the transformer or the
connection on a light chain (ensure that the light chain is
switched o). It is only possible to connect in one way.
Secure the connection by screwing the cap on the connector
to the thread on the transformer or the connection on a light
chain (ensure that the light chain is switched o).
4. To connect additional light chains, nets or curtains from the
Mix & Match DIY system, connect the corresponding plug to
the socket on this product. The plug can only be inserted in
one orientation.
Secure the connection by screwing the cap onto the thread.
The product is expandable. You can combine a maximum of
1050 LEDs in one system up to a length of 50 m.
Open ends should be sealed tightly before use. Screw the
cap to the thread on the connection socket that is not in use.
5. Connect the transformer to a power outlet.
6. The LEDs will turn on.
7. To turn o the product, unplug the transformer from the
mains socket.
The product has no power switch and is always on as long as
it is connected to the power supply.
Maintenance and cleaning
• The product is maintenance-free apart from occasional
cleaning.
• Before cleaning the product, disconnect it from the power
supply and let the LEDs cool down.
• To clean, use a clean, dry, lint-free cloth. For stubborn dirt,
slightly dampen the cloth with water.
• Allow the product to dry completely before continued use.
Disposal
Electronic devices are recyclable waste and must not
be disposed of in the household waste. At the end of its
service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute
to the protection of the environment.
Technical data
Item No. 1426524 1426525
Protection type IP44
Operating voltage 31 V/DC
Power consumption max. 1.35 W
Number of lights 100
Luminous colour Warm White
Total length approx. 2.5 m approx. 1.3 m
Operating conditions -20 to +70 °C / 0 – 100 % RH
Storage conditions -20 to +70 °C / 0 – 100 % RH
Weight approx. 230 g approx. 182 g
These operating instructions are published by CEI Conrad Electronic International (HK) Limited, 18th Floor, Tower 2,
Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong Kong. All rights including translation reserved.
Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data processing systems
require the prior written approval by the editor. Reprinting, also in part, is prohibited. The operating instructions
reflect the current technical specifications at time of print.
© Copyright 2016 by CEI Conrad Electronic International (HK) Limited
1426524_1426525_v1_0615_02_m_EN
distributed by Conrad Electronic SE,
Klaus-Conrad-Str. 1, D-92240 Hirschau
1426524
2.5 m
1426525
1.3 m