Owner's Manual

more information @ www.polkaudio.com 17
english
DXi 6501
figure 12
surface mount tweeter mounting
1. Using the base of the surface
mount cup as a template, mark
the screw hole and drill them
using a 1/8" (3mm) drill bit. Drill
a second hole (for the speaker
wire) using a 3/16" (5mm) drill bit.
2. Screw surface mount cup to the panel.
3. Push the tweeter wires through the open area at the bottom of the cup and
through the 3/16" (5mm) hole in the panel.
4. Connect wires from the tweeter terminals of the Crossover to the tweeter
wires using fast on connectors. Be sure to connect the red wire strand from
the tweeter to the (+) terminal of the crossover tweeter output.
5. Mount the tweeter by snapping it into the mounting cup.
français
figure 12
montage du tweeter—en surface
1. Utilisant la base de la coupelle comme gabarit, marquez les trous de vis puis
percez le panneau à l’aide d’une mèche de 1/8" (3 mm). Percez un deuxième
trou (pour le l de haut-parleur) utilisant une mèche de 3/16" (5 mm).
2. Vissez la coupelle à la surface du panneau.
3. Passez le ls du tweeter à travers le trou à la base de la coupelle et à travers
le trou de 3/16" (5 mm) déjà percé dans le panneau.
4. Conecte cables desde las terminales de tweeter del crossover hasta los
cables del tweeter con conectores faston. Asegúrese de conectar el cable
rojo del tweeter a la terminal (+) de la salida de tweeter del crossover.
5. Monte el tweeter haciéndolo encajar a presión en la copa de montaje.
gure 12