RCi SERIES RC60i RC80i RC55i RC65i RC85i O w n e r ’s Manual High Performance In-Wall Speakers the speaker specialists ®
PLACEMENT OPTIONS ADJUSTING THE TWEETER Polk Audio RCi Series In-Wall Loudspeakers give you nearly endless placement options. But remember that placement choice for your in-wall speakers bears careful consideration, as installation requires that you cut a hole in your wall! Aiming the tweeter toward your listening position improves imaging and detail. When using RCi Series In-Wall Loudspeakers as front/main home theater speakers [figure 2], aim the tweeter toward your listening position.
PAINTING YOUR RCi SERIES IN-WALL LOUDSPEAKERS You will need: • Paint of your choice (to make the job easier, we recommend spray painting the grille) • A paperclip or corkscrew (for removing the paintable grille, corkscrew can also be used to open the wine when you relax with your newly painted RCi speakers)) • Masking tape • Paint mask (to cover unpaintable parts, supplied!) PREPARING TO PAINT: PAINTING THE FRAME: 1. Separate the parts of the speaker.
INSTALLATION YOU WILL NEED: FOLLOW THESE EASY STEPS: Out of the box and into the wall, that’s how easy it is to install Polk RCi Series In-Wall Loudspeakers. • Pencil for marking the location of installation • Make sure the material into which you plan to mount the speakers (plaster, drywall, paneling, stone, etc.) can support the weight of the speakers (see specification page for the weight of your model).
SAFETY FIRST • To install the speaker, first carefully remove the grille using a straightened paperclip or other pointed metal tool. Insert the point into one of the grille perforations near a corner and lift the grille free. Never use a knife or screwdriver to pry between the grille and the speaker frame. This will damage your speaker. • Loosen the rotating wall clamps by unscrewing them.
SPECIFICATIONS RC55i RC65i RC85i Frequency Response 67Hz-20Khz 32Hz-20Khz 30Hz-20Khz Recommended Power Impedance Efficiency (dB 1w/1m) Drive Unit Complement Mid-Bass 20-100wrms 20-100wrms 20-100wrms Compatible with 8 Ohm amplifiers Compatible with 8 Ohm amplifiers Compatible with 8 Ohm amplifiers 89db 89db 90db 1–54" (13.3cm) mineral filled polypropylene cone, rubber suspension w" (1.9cm) soft dome in swivel mount 1–62" (16.5cm) mineral filled polypropylene cone, rubber suspension w" (1.
the speaker specialists 5601 METRO DRIVE, BALTIMORE, MARYLAND 21215, USA, 800-377-7655, FAX: 410-764-5266 www.polkaudio.
Thank you for purchasing Please send other correspondence to: NO POSTAGE NECESSARY Polk Audio, Inc. 5601 Metro Drive Baltimore, MD 21215 IF MAILED INTHE UNITED STATES 129 E BUSINESS REPLY MAIL FIRST-CLASS MAIL PERMIT NO.
REGISTER It's faster...easier...and you get COOL stuff! Register on-line to get: • An entry into a monthly drawing for a free Po~k subwoofer (home or car, your choke) • The peace of mind that we have a record of your purchase to verify purchase date and warranty status. • Privacy. The data we gather on our on-line registration is never sold or otherwise shared with anyone. • Free membership in Club Polk. Club Poik members enjoy valuable services and benefits not available to the general pubHc.
RM 0296-1 PRODUCT REGISTRATION CARD By completing and returning the attached Product Registration Card you will: • CONFIRM YOUR WARRANTY • REGISTER YOUR PRODUCT • PROTECT YOUR NEW PRODUCT PLEASE FOLD AND SEAL WITH TAPE BEFORE MAILING. DO NOT STAPLE.
RC65; Mounting Template Follow these steps before installing the RC65i. 1) Determine speaker location. Be sure that it does not interfere with studs/joists. 2) Hold or tape the template to the mounting location. Be sure the template is level. 3) Trace along the outside of the template. 4) Carefully cut a hole ensuring that it is no larger than the shape you traced. 5) Remove the speaker grilles. 6) Attach ttie speaker wires to the spring clips on the back of the speaker.
Lifetime Warranty for Polk Audio In-Wall and In-Ceiling Speakers (For Products purchased after September 9, 2009) • • • • Polk Audio warrants to the original retail purchaser that Polk Audio branded in-wall and in-ceiling speakers, including passive CSW series subwoofers (collectively "product"), will be free from defects in materials and workmanship for the life of the product, under normal use and conditions.
TO ASSUME FOR IT ANY LIABILITY IN CONNECTION WITH THE SALE OF THE PRODUCT. POLK HAS ABSOLUTELY NO LIABILITY FOR ANY ACTS OF THIRD PARTIES. SOME STATES DO NOT ALLOW THE EXCLUSION OF CERTAIN IMPLIED WARRANTIES, OR CONDITIONS ON AN IMPLIED WARRANTY, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU. POLK DOES NOT ACCEPT LIABILITY FOR SPECIAL, INDIRECT, INCIDENTAL, PUNITIVE OR CONSEQUENTIAL DAMAGES, LOST PROFITS, LOST SAVINGS OR DAMAGES RESULTING FROM IMPROPER USE, OR THE INABILITY TO USE THE PRODUCT.