Owner's Manual

RC65;
Mounting Template
Follow these steps before
installing the RC65i.
1) Determine speaker location.
Be sure that
it does not interfere with studs/joists.
2) Hold or tape the template to the mounting location.
Be sure the template is level.
3) Trace along the outside of the template.
4) Carefully cut a hole ensuring that it is no larger
than the shape you traced.
5) Remove the speaker grilles.
6) Attach ttie speaker wires to the spring clips on the
back
of the speaker. Use REO'for the positive (+) wire
and BLACK
for the negative (-) wire.
7) Loosen the six screws until the wall clamps swing freely.
8) Rotate the six mounting clamps inward and insert the
speakers into the wall opening.
9) Level the speakers and tighten the six screws until snug.
CAUTION: DO NOT OVER-TIGHTEN SCREWS!
10) Reinstall grilles.
Refer
to owner's manual for further installation instructions.