Operation Manual

ENGLISH Espresso 3000

1) Remove the top cover (10) and fill the water reservoir

(11) taking care not to overfill above its 1.3 litre capacity

(fig. 1).

2) Remove the cover of the coffee container (12) and fill

with coffee granules (fig. 2). With ESPRESSO 3000 you

can vary the degree of coffee-grinding.

To do this, push the grinding regulator button (13) and

rotate the container (12) clockwise for finer grinding and

anti-clockwise for a coarser grade.

3) Switch on the general ON/OFF switch (1) on the side of

the appliance (fig. 3).

Check that the indicator lights “ON” (2) and “coffee

dispensing” light (4) have lit up.

When the coffee dispensing indicator light (4) goes out

ESPRESSO 3000 is ready to dispense coffee.

This indicator light subsequently goes on and off from

time to time, indicating that the appliance is maintaining

water at constant temperature. This is an entirely normal

function.

Before first use, or when the machine has not been

used for some time, we recommend that the water

reservoir (11) should be emptied and washed out.

Then commence a full operation so as to clean out the

entire system (do not drink the coffee from this

operation).

We recommend the use of a coffee bag or ground

coffee in this operation. This will guarantee the

wonderful aroma of your subsequent cups of coffee.

1a) Insert the required filter for the number of cups (1 or 2)

in the filter holder.

2a) Locate the filter holder against the grinder start button

(8). By the filter holder pressing against this button,

the ground coffee will start to fall into the filter holder

(fig. 4).

3a) Once you have the desired amount of coffee, pull the

filter holder from the button and compress the coffee

provider on the compress (15) (fig. 5).

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5