Use and Care Manual

PORT-A-COOL OWNER’S MANUAL • PAGE 8
PAGE 27 • PORT-A-COOL OWNER’S MANUAL
PUMP REPLACEMENT
MODELS PAC2K163S, PAC2K163SHD, PAC2K16HPVS
1) DISCONNECT POWER and remove pads.
2) Remove output tubing from insert fitting on base of pump.
(Figure 1-A)
3) Remove the switch box wiring cover and disconnect the 4-pin
quick release connector from the pump switch assembly.
(Figure 1-B)
4) Remove the pump from the sump tank by removing two screws
that hold the pump cover and pump in place.
(Figure 1-C)
5) Remove the pump cover from old pump install onto the
new pump.
6) Reverse the above procedures to install the new pump.
7) Replace the cooling pads, positioning as shown on the air flow label.
8) Reconnect the unit power and test pump.
PUMP REPLACEMENT
MODEL PAC3SVT, PACJS1600, PACJS2400
1) Disconnect electrical power to unit and remove pads.
2) Remove the cover plate on the electrical box to disconnect the
motor quick connect and the zip ties holding it together.
(Figure 1)
3) Remove the pump from the sump.
8) Install new pump by reversing above steps.
Figure 1
Figure 1
1-A
1-B
1-C
PORT-A-COOL® UNIT OVERVIEW
Control
Panel
Electrical
Plug
Cord Wrap
Hose
Connection
Locking
Casters
Drain
Valve
Water
Adjustment
Valve