Instructions / Assembly

08 PK360 | OWNER’S GUIDE
ASSEMBLY INSTRUCTIONS
STEP
2
1) Place Control Tower™ Base flat, right side up on a level surface with the
wheels on your left. Twist the adjustable feet as needed to balance and
stabilize the Base.
2) Orient the Control Tower™ Tube so the tab on the bottom of the tube is facing
toward you. Slide the Tube down through the hole in the Base into the Mount
Cu until the tab fits into the slot on the Mount Cu.
3) Holding the Tube and Base together, turn the assembly over and rest it on the
tube with the bottom of the Base facing upward. Verify that the Tube tab is
flush in the Mount Cu slot.
4) Using the provided hex wrench, tighten each of the four bolts on the bottom of
the Mount Cu one at a time in a circular pattern until tight. Repeat tightening
in a circular pattern until all bolts are tight and the tube feels very secure in the
base. Do not over tighten.
5) Set aside.
ASSEMBLE CONTROL TOWER™ TUBE TO BASE:
01. 02.
03. 04.
MOUNT CUFF