Router User Manual

12
6. Tighten collet nut (D) Fig. 10 with
wrench provided.
7. To remove bit, loosen collet nut.
If bit does not remove easily,
continue to loosen the collet nut
until the nut forces the collet
retaining ring to lift and free
collet.
8. Reinstall the chip deflector.
ADJUSTING PLUNGE DEPTH
DISCONNECT TOOL FROM POWER SOURCE.
1. Loosen depth rod locking knob
(K) Fig. 11, and depth indicator
knob, (J) Fig. 11, allowing the
depth rod (L) Fig. 11 to contact
one of the depth stops (M) Fig.
11. Normally the deepest cut is
set with the depth rod (L) Fig. 12
resting on the base casting (A)
Fig. 12. Adjust the three
adjustable stops (B) Fig. 12 to
any desired height to allow stock
removal in steps. This action or
the various depths that m y be
required for a particular job.
2. Release the plunge mechanism by pulling the locking lever (B) Fig. 8 to the
left and lower the plunge mechanism until the router bit just touches the
work surface. Release the lever and push to the right to lock the
mechanism in this position.
3. Tighten the depth rod locking knob (K) Fig. 11.
4. Position the depth indicator (J) Fig. 11 at “O” position and tighten knob.
5. Loosen the depth rod locking knob (K) Fig. 11, and raise the depth rod until
the indicator aligns with the graduation representing the desired depth of
plunge (The example in Fig. 13 shows the setting for 1" plunge). Tighten
the depth rod locking knob.
D
Fig. 10
J
H
K
Fig. 11
M
L
B
A
Fig. 12
L
Fig. 13