Router User Manual

15
ADJUSTING PLUNGE LOCKING LEVER
The plunge locking mechanism may be adjusted to compensate for wear, or
to reposition lever (in locked position). To adjust:
DISCONNECT TOOL FROM POWER SOURCE.
1. Lock the plunge locking lever, (A) Fig. 17, by moving it to the operator’s
right as far as it will go.
2. Push in on the plunge locking lever (A) Fig. 17.
3. Move the plunge locking lever (A) Fig. 17 to the desired location and allow
it to spring back into position.
Adjust the plunge locking mechanism in the following manner:
:
1. Hold the plunge-locking lever (A) Fig. 16.
2. Insert
3
/32" hex wrench (not furnished) through the center of the plunge locking
bolt (B) Fig. 16 into the adjustment screw, and turn counterclockwise
approximately one turn.
3. Push in on the plunge-locking lever (A) Fig. 17 to expose the head of
plunge-locking bolt (B) Fig. 17.
4. While holding plunge-locking lever in (A) Fig. 17, turn plunge-locking bolt
(B) Fig. 17 clockwise to turn the plunge-locking bolt in or
counterclockwise to turn the plunge-locking bolt out. Turn it one position
at a time until proper adjustment is achieved. Proper adjustment is
indicated when the plunge- locking lever (A) Figs. 18 and 19 can be
locked into the free motion position (Fig. 18), and into the plunge-locked
position (Fig. 19).
5. Move plunge locking lever (A) Figs. 18 and 19 to the center of those 2
positions. Insert the allen wrench through the center of the plunge
locking bolt (B) Fig. 16 into adjustment screw. Turn clockwise to tighten.
Fig. 16
A
B
Fig. 17
A
B
Fig. 19
A
Fig. 18
A