Manual

TYPICAL INSTALLATION OF BATTERY
. Recommended Battery for Electnc Start: 12V - 45 A H. or 210 CCA (Cold
Cranking Amps)
Purchase battery and battery hardware separately, not included with unit.
_. Place battery in Packwith terminals facing to-
wards generator head.
2. Place battery bracket (A) over battery as
shown in Figure (opposite battery terminals),
3. Place 'L' bolt (B) through top and bottom
brackets and secure with wing nut (C).
4,
5.
Locate the solenoidon the left side
of the unit.
Remove the nut from the solenoid
poet and place one end of the posi-
tive (red) battery cable onto the
poet. Reassemble nut and tighten
securely.
Lawn & Garden batteries can
come in two terminal _ -- _ -_- []
configurations. The Positive (+) and NegaBve (-)
terminals can be oriented so that _ey are +/-
or -/+, See Figure. In the unlikely event th_ the
battery terminals are unmarked, we
recommend that you return the battery to the
retailer for exchange for a properly marked
battery or let an authorized service center inet_ll the b_'_teryfor you. Failure
to connect the battery properly can possibly cause bodily injury. In addition,
extensive engine electrical damage not covered under warranty can result.
6. Attach the other end of the positive
Ired) battery cable to the positive 0)
terminal on the battery.
TO Prevent sparks
connect the red
_osiBve) cable to the positive (+)
terminal before connecting the black
negative cable,
7. Attach one end of the negative
Iblack) cable to the negative (-)
terminal on the battery.
8. Attach the other end of the negative
(black) cable to the frame as shown,
Install the star washer between the
cable and the frame.
IMPORTANT: See caution before
connecting cable to battery.
_-t e _ Cable
D'29525 10 ENG