Manual

PROBLEM
Engine will not
start
No electrical
output
CAUSE
1, Low on fuel or oil.
2. Ignition switch in "Off"
position.
3, Faulty spark plug,
4. Choke in wrong position.
5, Fuel shut-off valve in
closed position
6. Unit loaded during start-
up.
7. Spark plug wire loose.
Faulty receptacle.
Circuit breaker kicked
out,
Defective capacitor.
Faulty power cord,
GFCI switch breaker
kicked out,
Repeated 1, Overload
circuit breaker 2, Faulty cords or
tripping equipment
Generator 1, Generator overloaded,
overheating 2, Insufficient ventilation.
No auto idle 1, Faulty solenoid
2, Faulty idle control switch
3 Faulty windings in stetor
DC does not
have power
with the
circuit breaker
depressed
4, Faulty circuit board
5 Faulty wire harness
1. Faulty rectifier
2. Faulty windings in stetor
3. Faulty wiraharness
CORRECTION
1, Add fuel or oil.
2. Turn to :'ON" position
3. Replace spark plug.
4. Adjust choke accordingly,
5, Open fuel shut-off valve.
6. Remove load from unit.
7. Attach wire to spark plug.
1, Have Service Center
replace,
2, Depress and reset.
3, Have Service Center
replace capacitor.
4, Repair or replace cord.
5, Depress and reset
1, Reduce load.
2, Check for damaged, bare,
or frayed wires on
equipment. Replace.
1, Reduce load.
2, Move to adequate supply
of fresh air,
1, Have Service Center
replace,
2, Have Service Center
replace,
a3. Have Service Center
replace,
4, Have Service Center
replace,
5, Have Service Center
replace,
1, Have Service Center
replace,
2, Have Service Center
replace,
3, Have Service Center
replace,
2 ENG D2£525