Use and Care Guide

CAUTION:

●All electrical connections must be in agreement with local codes, ordinances or the National

Electric Code (NEC). Contact your municipal building department to learn about your local codes,

permits and/or inspections.

●Risk of fire — most dwellings built before 1985 have supply wire rated for 140ºF/60ºC. Consult a

qualified electrician before installation.

●Do not connect this fixture to an electrical system that does not provide a means for equipment

grounding. Never use a fixture in a two-wire system that is not grounded. If you are not sure your

lighting system has a grounding means, do not attempt to install this fixture. Contact a qualified,

licensed electrician for information with regards to proper grounding methods as required by the

local electrical code in your area.

●If a dimmer control switch is used with this fixture, obtain professional advice to determine the

correct type and electrical rating required.

PREPARATION

Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare

parts with package contents list and hardware contents list. If any part is missing or damaged, do

not attempt to assemble, install or operate the product.

Estimated Assembly Time: 30 minutes.

Tools Required for Assembly (not included): Concrete, Flathead Screwdriver, Phillips Screwdriver,

Pliers, Electrical Tape, Wire Cutters, Safety Glasses, Ladder, Wire Stripper, 1/2 in. Wrench.

ASSEMBLY INSTRUCTIONS

1. Excavate an area in the ground deep enough to enclose the

height of the anchor bolts (BB). Route the electrical wire

from the power supply underground and out through the

middle of the installation area. Screw the anchor bolts (BB)

into the mounting bracket (AA). Fill hole with concrete (not

included) and insert the assembly before the concrete dries.

Note: The mounting bracket (AA) should be at ground level,

with the anchor bolts (BB) 1-7/8 in. above the ground.

Hardware Used

Mounting Bracket x 1

Anchor Bolt x 3