Instruction manual

17
REPLACE SPARK PL UG
The spark plug should be replaced each
year to ensure the engine starts easier and
runs better. Ignition timing is fixed and non-
adjustable.
NOTE: This spark ignition system complies
with the Canadian standard ICES--002.
1. Loosen knob on air filter cover. Remove
air filter cover.
2. Pull off the spark plug boot.
3. Remove spark plug from cylinder and
discard.
4. Replace with Champion RCJ--7Y spark
plug and tighten securely with a
3
/
4
inch
(19 mm) socket wrench. Spark plug gap
should be 0.025 inch (0.6 mm).
5. Reinstall the spark plug boot.
6. Reinstall air filter cover . Tighten knob se-
curely.
Spark
Plug
Boot
Air Filter
Cover
Knob
REPLACE FUEL FILTER
To replace fuel filter (part #530095646), drain
your unit by running it dry of fuel. Remove fuel
cap and its connected retainer from tank. Pull
filter from tank and remove from line. Replace
and reassemble.
CHAIN ADJUSTMENT
See CHAIN TENSION in ASSEMBLY section.
CHAIN SHARPENING
WARNING: Improper chain sharpen-
ing techniques and/or depth gauge mainte-
nance will increase the chance of kickback
which can result in serious injury.
WARNING: Wear protective gloves
when handling chain. The chain is sharp and
can cut you even when it is not moving.
Conditions which indicate the need for chain
sharpening:
S Reduction in size of wood chips. The size
of the wood chip will decrease as the chain
gets duller until it becomes more like a
powder than a chip. Note that dead or
rotted wood will not produce a good chip.
S Saw cuts to one side or at an angle.
S Saw has to be forced through the cut.
Too ls required:
S 7/32 inch (5 mm) diameter round file and
file holder
S Flat file
S Depth gauge tool
TO SHARPEN CHAIN:
1. Move ON/STOP switch to the STOP
position.
2. Check chain for proper tension. Adjust
chain tension if necessary . See CHAIN
TENSION section.
3. Sharpen cutters.
S To sharpen the cutters, position the
file holder level (10° ) so that it rests
on the top edges of the cutter and
depth gauge.
NOTE: The chain has both left and
right hand cutters.
Depth Gauge
File
File Holder
Cutter
10°
S Align the 25° file holder marks paral-
lel with the bar and to the center of the
chain.
Cutter
Cutter
25°
File Holder Line
S Sharpen cutters on one side of the
chain first. File from the inside of each
cutter to the outside. Then, turn the
chain saw around and repeat the pro-
cess for the other side of the chain.
S File on the forward stroke only. Use 2
or 3 strokes per cutting edge.
S Keep all cutters the same length
when filing.
S File enough to remove any damage
to cutting edges (side plate and top
plate of cutter).
A
ll Cutters
Same Length
Remove Damage
Top Plate
Side Plate
S File chain to meet the specifications
as shown.
25°
60°
60
°
Rounded
Corner
0.025 inch
(0.65 mm)
Right
Hook Angle