- Weed Eater Gas Blower Instruction Manual

-- 5 --
OPERATING THE COUPLER
Your powerhead is equipped with a coupler
which enables optional attachments to be
installed. The optional attachments are:
MODEL:
Edger
1000E.......................
Cultivator
2000T...................
Brushcutter
4000C.................
WARNING:
Always disconnect pow-
erhead spark plug (or disconnect powerhead
from power source) before removing or instal-
ling attachments.
REMOVING ATTACHMENT
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Knob
LOOSEN
TIGHTEN
Upper Tube
Lower
Attachment
2. Pr ess and hold the locking/release button.
Locking/Release
Button
Coupler
Upper Tube
Lower Attachment
3. While securely holding the upper tube,
pull the attachment straight out of the
coupler.
INSTALLING ATTACHMENT
1. Remove the tube cap from the attach-
ment (if present) and discard.
2. Position locking/release button of attach-
ment into guide recess of upper tube cou-
pler.
Coupler
Primary Hole
Upper
Tube
Locking/
Release
Button
Attachment
Guide Recess
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning c lock wise.
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use. To install hang-
er on attachment:
1. Remove the tube cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release but-
ton.
3. Push hanger onto the attachment until
the locking/release button snaps into the
hole.
OPERATING POSITION
Eye Protection
ALWAYS WEAR:
WARNING:
Inspect the area before
using the unit. Remove all debris and hard
objects such as rocks, glass, wire, etc., that
can ricochet, be thrown, or otherwise cause
injury or damage during operation.
Use your blower attachment for:
S
Sweeping debris or grass clippings from
driveways, sidewalks, patios, etc.
S
Blowing grass clippings, straw, or leaves into
piles, or removing debris from corners,
around joints, or between bricks.
Control air flow by directing the blower dis-
charge opening down or to one side. Always
work away from solid objects such as walks,
large stones, vehicles, and fences.
Clean corner s by starting in corner s and moving
outward. This will help prevent an accumulation
of debris which could fly into your face.
Be careful when working near plants. The force
of the air could damage tender plants.