Use and Care Manual

Belts squeal in neutral and/or reverse
• Adjust forward belt guide:
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark
plug
- remove belt guard
- pull down on drive safety control levers
- manually bend forward belt guide so there is 1/16
inch or less clearance between belt guide and belt
- replace belt guard and spark plug wire
Belts squeal in forward operation
• Adjust tabs on the reverse belt guide
- turn engine off and allow muffler to cool
- disconnect spark plug wire and secure from spark
plug
- release drive safety control levers to neutral
position
- remove belt guard
- adjust tabs of reverse belt guide:
while drive safety control levers are released, bend
metal tabs on reverse belt guide to 1/64 inch or less
clearance from reverse belt
- replace belt guard and spark plug wire
Excessive heat build up in
transmission/tine area during tilling
• Remove vegetation by following instructions in
clean Tine Axle Shaft of Normal care section.
FOLLOW ALL SAFETY INSTRU
CTIONS
• Check transmission fluid and fill if needed
TECHNICAL DIAGRAM
Tilling Scope
500mm
Tilling Depth
175~350mm
Gear Shifting
0, 1,
-1
Engine Type
OHV 4
-stroke
Starting System
Recoil
Displacement
196
cc
Max Output
6.
5HP/3600rpm
Engine Speed
3600rpm
Fuel
Volume
3.6
L
Oil Volume
0.6 L
Fuel Type
Unleaded Gasoline