Operation Manual

Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group © 2007 PowerBoss
®
CORE 50 Sweeper Scrubber Page 15
PowerBoss
®
The Power of Clean
SWEEPING CONTROLS
SIDE BROOM
SWITCH
MAIN BROOM
SWITCH
FLOAT
DUMP DOOR/
SHAKER SWITCH
When activated the switch lowers the side broom to the floor and
turns the broom on. This function only works when the main
broom is also activated.
When activated this switch:
٭ Opens the hopper dump door
٭ Lowers the main broom to the floor.
٭ Activates the broom motor.
٭ Activates the impeller motor.
The main broom function can be used alone or with the side
broom function.
By disengaging this switch, the following will occur:
٭ The hopper dump door closes.
٭ The main broom is raised.
٭ The main broom motor stops.
٭ The impeller motor stops.
The hand lever beside the operator’s left leg my be lowered to
provide a float position for the main broom. The float position
may be used on extremely uneven floors.
Extreme use of the float position reduces the broom life. For
normal sweepeing, the float lever should be raised and locked in
the upper position.
This switch is located on the left side of the control panel. It is
used to open the hopper dump door after the hopper is raised.
(See “Debris Hopper Controls”). The other side of the switch is
used to activate the filter shaker motor.
NOTE
SCRUBBING CONTROLS
FILLING THE
SOLUTION TANK
To fill the solution tank follow these steps:
1. Park the machine on a level area and lock the parking brake.
2. Open the top door of the tanks. Fill the tank with a clean
water solution.
3. When adding a chemical cleaning agent the “PowerBoss
Powersol” line of products are recommended. Follow the
directions on the label for proper mix ratio.