Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 16

PowerBoss

The Power of Clean

Never use detergents or cleaners that are flammable or

combustible. Always wear safety glasses when using

chemicals of any kind.

This machine is designed so that the scrub brushes will not

turn and solution will not be delivered to the brushes while

the machine is not moving.

To operate the scrub brushes, follow these steps:

1. Lower the scrubheads to the floor with the scrubhead

switch. This will lower the scrubhead and turn the

brushes on when the machine begins to move.

2. The scrubhead will apply the selected pressure to the

brushes.

3. To select the proper brush pressure for conditions,

locate the brush pressure selection knob on the left

console. There are four (4) selections. The lightest

pressure is applied with the knob turned to the left, the

heaviest to the right. Once set, it is not necessary to

change this knob as the scrubhead is raised and

lowered. Each time the brushes are activated, the

scrubhead will return to the setting selected.

For normal scrubbing, the main broom and side broom

remain off.

To sweep simultaneously, lower the brooms at this time.

4. When the scrubhead is lowered and the machine is

moved forward or reversed, solution will automatically

begin to flow. To select the rate of solution flow, locate

the solution control knob on the left console. If turned

completely to the left, no solution will flow. Rotating the

knob to the right will increase the flow through three (3)

more settings. It is not necessary to change this knob as

the scrubhead is raised or lowered. When the

scrubhead is raised, solution flow automatically stops.

When the scrubhead is lowered and the machine is

moved, solution flow resumes at the selected rate.

SCRUBBING CONTROLS (Continued)

CAUTION

NOTE

MAIN SCRUB

BRUSHES