Operation Manual

Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group © 2007 PowerBoss
®
CORE 50 Sweeper Scrubber Page 18
PowerBoss
®
The Power of Clean
DRAINING THE
RECOVERY TANK
CLEANING THE
RECOVERY
TANK
Follow these steps to drain the recovery tank:
1. Park the machine on a level surface at an approved
drainage site with the left rear of the machine beside the
drain access.
2. Engage the parking brake.
3. Turn the machine OFF.
4. Locate the drain hose on the left side of the machine
beneath the engine access side door.
5. Remove the flexible drain hose from its storage tray.
Pull out the drain hose for the required reach to the
access.
6. Place the end of the drain hose on or in the approved
drain access.
7. Loosen and remove the drain plug.
8. Drain the tank completely and reinstall the plug.
9. Reposition the drain hose on its storage tray.
To clean the recovery tank after draining, proceed as
follows:
The recovery tank should be cleaned after every shift.
1. Position the machine at an approved drain area.
2. Engage the parking brake.
3. Shut off the machine.
4. Remove the two 9” access caps at the sides of the unit.
5. Remove the drain hose and position it over the
approved drain opening.
6. Loosen and remove the drain plug.
7. Spray the tank with clean water, flushing all sludge out
of the access ports.
8. Remove the foam cap on top of the exit tube. Rinse and
reinstall.
9. Drain the tank completely and reinstall the drain plug.
10. Return the drain hose to the storage tray at the left side
of the machine beneath the engine.
11. Replace the 9” access caps removed in step four.
SCRUBBING CONTROLS (Continued)
NOTE