Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 19

PowerBoss

The Power of Clean

CLEANING THE

SOLUTION FILTER

DRAINING THE

SOLUTION TANK

HOPPER FILTER

SHAKER BUTTON

The Cleaning solution passes through a filter canister on its

way to the scrub brushes. This filter can be inspected and

cleaned even if the solution tank is full. This filter is located

on the right side of the machine beneath the foot pedal just

inside of the frame rail.

1. Locate the valve on the forward side of the filter canister

(the valve closest to the broom chamber). Turn the valve

ninety degrees (90°) to close.

2. Grasp the filter canister housing and unscrew. Remove

the housing. The element is inside of the housing and

can be removed for cleaning and inspection.

3. Reinstall the element and housing.

4. Open the valve.

A valve to the rear of the solution filter in the right frame rail

may be opened ninety degrees (90°) to drain the solution

tank.

This button is used to activate the filter shakers prior to

dumping or as needed during sweeping operation. It is

located to the left side of the instrument panel.

To shake the filter:

1. Bring the machine to a complete stop.

2. Place the broom switch in the OFF position.

3. Press and hold the filter shaker button for 20 to 30

seconds.

4. Place the broom switch in the ON position and resume

sweeping.

Do not leave the hopper in the RAISE position for an

extended period of time.

SCRUBBING CONTROLS (Continued)

CAUTION