Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 21

PowerBoss

The Power of Clean

PRE-OPERATION

CHECKS

STARTING

SLOWING AND

STOPPING

Prior to starting the engine, check the following:

1. Engine oil level

2. Engine coolant level

3. Fuel level

4. Hydraulic fluid level

5. Brakes, steering and directional controls

6. The floor beneath the machine for signs of fluid leaks

Fluid levels should be correct. Brakes, steering and

directional controls should be functioning properly. Hoses,

lines and tanks should be free of damage and leaks.

Before starting the engine, sit in the operator’s seat

and make sure the parking brake is locked.

1. Make sure the directional control pedal is in the neutral

position.

2. Make sure the throttle is in the idle position.

3. LP and Gasoline-powered: Turn the ignition switch to

the START position, then release.

Diesel-powered: Turn the ignition switch to the first

position, then press the glow plug switch for

approximately 15 to 20 seconds. Turn the ignition switch

to the START position and release.

If the engine fails to start, do not continue cranking for

more than ten (10) seconds. Allow the starter motor to

cool between attempts.

4. Allow the engine to warm for approximately two minutes.

1. Allow the directional control pedal to move into the

neutral position. The machine will slow and coast to a

stop.

OPERATING PROCEDURES

WARNING

NOTE