Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 22

PowerBoss

The Power of Clean

OPERATING ON

GRADES

SWEEPING

EMPTYING THE

HOPPER

1. Always travel slowly.

2. Exercise extreme caution when traveling across or

turning on grades

3. Use the brake pedal only for slowing the machine on

grades.

1. Lower the Brooms

٭ Lower the side broom by pressing the right side of the

side broom switch.

٭ Lower the main broom by pressing the right side of

the main broom switch.

* When sweeping extremely uneven floors, position the

FLOAT lever in the lowered position.

2. Drive the machine over the area to be swept.

1. Drive the machine to an approved dumping area.

2. Shake the filters for 20 to 30 seconds.

3. Use the directional control pedal to position the machine

so that the space between the machine and the

container or dumpster is adequate to raise the hopper.

4. Reduce the engine speed.

5. Pull back the lever to the RAISE position and hold until

the bottom of the hopper is high enough to clear the top

of the container.

Never place your hands or other body parts near the lift

arms when the hopper is operating.

6. Use the directional control pedal to slowly and carefully

move the machine forward until the hopper is properly

positioned to dump debris into the container.

It is unsafe to travel an extended distance with the

hopper raised. Travel only the distance necessary to

position the hopper.

7. Press and hold the left side of the Dump Door Open

switch.

8. After the hopper empties, slowly back the machine away

from the dumpster approximately five (5) feet.

9. Push the lever forward to the LOWER position until the

hopper stops.

CAUTION

WARNING