Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 23

PowerBoss

The Power of Clean

USING THE

ROTARY TRASH

RELOCATOR

(RTR™)

TRANSPORTING

THE MACHINE

Towing

Pushing

During sweeping, if the need arises, the RTR functions can

be accomplished as described below.

1. Use the directional control pedal to stop the machine on

a level surface.

2. Turn the main broom OFF by placing the switch in the

center “OFF” position.

This rotates the dump door, causing debris to move from

the rear entrance to the front wall of the hopper.

1. Position the machine on the transport vehicle or trailer

and apply the parking brake.

2. Tie the machine down using the tie down holes in the

frame behind both the front wheels and in the rear

center of the frame.

Attach the tie downs to the frame only. Do not attach

tie-downs to the swing-able engine frame.

To operate the tow valve:

1. Swing the engine open.

2. Locate the yellow lever under the forward wall of the

hydraulic reservoir.

3. Rotate the lever ninety degrees (90°) clockwise.

4. Push or tow the machine.

1. Push the machine from the rear using bumpers only.

Do not tow or push the machine a distance of more

than .5 miles (.80 kilometers) or faster than one mile per

hour (1.61 km). Exceeding these restrictions may cause

damage to the hydraulic system. If towing will exceed

the above restrictions, the rear wheel must be raised or

supported by a dolly.

NOTE

ATTENTION!