Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 24

PowerBoss

The Power of Clean

JACK POINTS

TIE DOWN

REMOVING LP

TANK

Hakomatic 1800

INSTALLING LP

TANK

Hakomatic 1800

To jack the machine, place the jack under the front edge of the

wheel well on the frame. To jack the rear of the machine, place the

jack under the main frame beneath the tail lights.

Each of the front walls of the wheel wells have an opening for

securing the machine in the front. In the right rear roller mount, two

holes are supplied for attaching a clevis or eyebolt for securing the

rear.

1. To remove the LP tank, loosen the knob to the left of the tank.

2. Rotate the locking bracket down.

3. Remove the knurled quick disconnect fitting at the tank.

4. Slide the tank out.

1. Release the latch on the retaining door for the LP tank and open

the door.

2. Remove the hose fitting from the tank and slide the tank out.

1. Place the tank, base first into the tank cavity below the

operator’s seat.

2. Slide the tank toward the engine until the tank is flush with the

outside of the machine frame. The locating hole should be on

the bottom.

3. Attach the quick disconnect hose to the tank and tighten.

4. Rotate the locking bracket upward so that the pin engages the

hole in the tank. Make sure that the locking tab on the back of

the locking bracket rests on the inside lip of the tank collar.

5. While holding the bracket in place, tighten the knob.

1. Same as above.

2. Same as above.

3. Same as above.

4. Rotate the tank so that the locating opening is facing downward.

5. Close the access door and secure the latch.

ATTENTION!

WARNING

Use jack stands to hold the machine. Do not rely on

the jack alone.

Do not attach tie downs to the swinging engine frame

as permanent machine damage may result.