Operation Manual

Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group © 2007 PowerBoss
®
CORE 50 Sweeper Scrubber Page 33
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
ELECTRICAL SYSTEM
BATTERY CLEANING
1. Combine baking soda and water in a strong solution.
2. Brush the solution over the battery top, including terminals and cable
clamps. Make sure the solution does not enter the battery.
3. Using a wire brush, clean the terminal posts and cable clamps.
4. Apply a thin coating of petroleum jelly to the terminals and cable clamps.
BATTERY REPLACEMENT
1. Disconnect the negative (-) cable and then the positive (+) cable.
2. Remove the battery.
3. Install the new battery.
4. Connect the positive (+) battery cable first, then the negative (-) cable.
CIRCUIT BREAKERS
If the circuit breaker trips, it can be reset by pressing the reset button in the
center of the breaker. (The circuit breaker is located on the instrument panel
beside the ignition switch).
FUSES
The individual circuits are protected by automotive style fuses in a fuse panel.
This panel is located beneath the large plastic cover beside the battery. The
engine compartment. To access the fuses, remove the wingnut in the center of
the plastic cover. Then remove the cover.
AUTO RESET CIRCUIT BREAKERS
The headlights, tail lights, and horn circuits are protected by automatically
resetting circuit breakers. The left headlights are on a separate circuit than the
right headlights. Should these circuits experience an overload condition, the
circuit breaker will stop current flow and reset itself after a brief time. If current
interruption persists, turn off this circuit and report fault to technician.
CAUTION
Remove the negative battery cable before you remove the
positive battery cable. This is done to prevent accidental
electrical shorting which can result in personal injury.