Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 38

PowerBoss

The Power of Clean

SERVICE INSTRUCTIONS (CONTINUED)

HYDRAULICS SYSTEM

FILLING THE FLUID RESERVOIR

1. When the machine is cool and the hopper is in the lowered position, remove

the fill cap located in the top of the fluid reservoir. Fluid level should be to the

grove on the dipstick attached to the fill cap.

2. If the fluid level is not acceptable, add hydraulic fluid.

SUS @100° F 510-560

SUS @ 210° F 78-84

CHANGING THE HYDRAULIC FLUID

1. Turn off the engine and engage the parking brake.

2. Swing the engine frame open and secure with the locking pin.

3. Place a drain pan on the floor below the reservoir.

4. Remove the drain plug located on the bottom rear of the reservoir and

allow the fluid to drain.

5. Discard the fluid in an approved manner, then replace and retighten the

drain plug.

6. Remove the filler / breather cap located on top of the reservoir and fill the

reservoir with approved hydraulic fluid.

7. Check the dipstick to ensure the proper level is achieved.

8. Remove the dipstick from the old cap and attach to a new fill cap / breather.

9. Install the new filler / breather cap assembly.

10. Check the drain plug for leakage.

NOTE

HYDRAULIC FLUID VISCOSITY SPECIFICATIONS

The reservoir is located inside the machine and is

accessible through the top side door.

CAUTION

DO NOT OVERFILL! DO NOT USE TRANSMISSION FLUID

INSTEAD OF HYDRAULIC FLUID. HYDRAULIC OIL MUST

MEET THE SPECIFICATIONS LISTED TO ENSURE

PROPER PERFORMANCE.

NOTE

Fourteen (14) gallons (US) (53 liters) of fluid are required.