Operation Manual

Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group © 2007 PowerBoss
®
CORE 50 Sweeper Scrubber Page 43
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
SWEEP COMPONENTS (CONTINUED)
MAIN BROOM TAPER ADJUSTMENT
Main Broom Taper
Patterns
1. Locate the hex-shaped adjustment bar on the left rear wall of the broom
chamber underneath the machine.
2. Loosen the retaining bolt on the right side of the hex bar.
3. Grasp the hex bar with a wrench and rotate it to raise or lower the left end
of the main broom. (The right end of the broom remains fixed. All
adjustments affect the left end of the broom.)
4. After adjustment, re-tighten the bolt.
5. Repeat the main broom adjustment test to see that the broom is properly
adjusted.
NOTE
Correct Taper Pattern
Incorrect Taper Pattern
It is not usually necessary to perform this adjustment. However, if the
main broom adjustment test shows a pattern that is tapered in length
(one end is wider than the other), perform the procedures which follow.