Operation Manual

Owner’s Manual

CORE 50 Sweeper Scrubber Page 45

PowerBoss

The Power of Clean

SERVICE INSTRUCTIONS (CONTINUED)

SWEEP COMPONENTS (CONTINUED)

SIDE BROOM HEIGHT (WEAR) ADJUSTMENT

The side broom wear adjustment is controlled in ½” steps. These steps are

accomplished using the two pins in the side broom adjusting block.

1. Lift the hopper cover to the open position.

2. Set the parking brake.

3. Start the engine and lift the hopper.

4. Stop the engine and engage the hopper safety arm.

5. Locate the side broom side block on the side of the hopper. Remove the

pin closest to the actuator and insert on the side of the hopper. Remove

the pin closest to the actuator and insert it into the hole on the opposite

side of the remaining pin while putting tension on the cable. Make sure the

repositioned pin goes through the loop in the cable (inside of the plastic

block). Repositioning the pin places the cable closer to the floor when the

lopper is lowered.

6. Make sure the pins are securely seated.

7. Start the machine and lower the hopper.

8. Close the hopper cover.

SIDE BROOM ANGLE ADJUSTMENT

The side broom can be adjusted to raise or lower the front leading edge of the broom. To

adjust:

1. Locate the two ½” hex nuts on the plate behind the side broom motor. This

plate is located between the motor and the hopper.

2. Loosen both nuts using a ½” wrench.

3. Move the broom to the desired angle.

4. Retighten both nuts.

CAUTION

DO NOT RELY UPON THE HYDRAULIC CYLINDER TO KEEP THE

HOPPER RAISED FOR MAINTENANCE. ALWAYS ENGAGE THE

SAFETY ARM BEFORE GETTING UNDER THE HOPPER.