Operation Manual

Owner’s Manual
R
PowerBoss, Inc. A Member of the Hako Group © 2007 PowerBoss
®
CORE 50 Sweeper Scrubber Page 46
PowerBoss
®
The Power of Clean
SERVICE INSTRUCTIONS (CONTINUED)
SWEEP COMPONENTS (CONTINUED)
SIDE BROOM REPLACEMENT (Bristles worn to a length of 3 inches; 7.62 cm or less)
1. Stop the machine and set the parking brake.
2. Turn the side broom by hand until the brush retainer bar is accessible.
3. Lift the bar and turn the broom clockwise (about one eighth of a turn) until
the lock pins in the broom disengage from the drive plate.
4. Install the new broom by positioning the three drive pins into the pilot holes
of the drive plate.
5. Lift and rotate the broom until the broom retainer bar springs into the
locked position.
6. Check to make sure all three drive pins are properly engaged.
NOTE
The side broom features a quick release mechanism which
enables the operator to remove the brush in seconds.